Florida AHJ
Solar permit requirements in Cutler Bay, FL
Cutler Bay is located within Miami-Dade County and is designated as a High-Velocity Hurricane Zone. Solar projects in this jurisdiction must adhere to specific structural and fire safety standards to receive permit approval.
Requirements at a glance
- Design wind speed
- 175 mph (ASCE)
- Exposure category
- C
- Ground snow load
- 0 psf
- High-velocity hurricane zone
- Yes
- Fire access pathways
- Required
- Submission format
- Hard copy required
- Separate discipline files
- No
What Cutler Bay expects on a solar permit
All solar installations require hardcopy submission of plans. Structural designs must account for 175 mph wind speeds, Exposure Category C, and Risk Category II per FBC 2023 and ASCE 7-22, with a minimum of 3 inches of embedment into roof trusses for all lag screws. Documentation must include a Notice of Employment as Special Inspector form signed by a Florida PE or Architect, a PE-sealed Letter of Compliance at final, and module datasheets with highlighted UL 1703 listings. Fire safety mandates include a 36-inch clear setback on both sides of a horizontal ridge for arrays occupying over 33 percent of the roof area, or 66 percent if the building is sprinklered, with these dimensions noted in the plan legend. A rapid shutdown pathway placard is also required.
- [structural] Design structural plans for 175 mph wind speed, Exposure Category C, and Risk Category II per FBC 2023 and ASCE 7-22.
- [documentation] Submit a 'Notice of Employment as Special Inspector' form (per Miami-Dade Sec. 8-22) signed and sealed by a FL PE or Architect for roof anchoring, and provide a PE-sealed Letter of Compliance at final.
- [fire] Provide a 36-inch clear setback on both sides of a horizontal ridge for arrays occupying >33% of the roof area (66% if sprinklered) per 2023 FBC R324.6.2, and explicitly note these dimensions and code references in the plan legend.
- [structural] Specify a minimum of 3 inches of embedment into roof trusses for all lag screws.
- [documentation] Provide module datasheets with UL 1703 listings explicitly highlighted to demonstrate compliance with 2023 FBC R324.3.
Cutler Bay building department
- Website:
- https://www.cutlerbay-fl.gov
Always confirm current requirements and fees directly with the Cutler Bay building department before submitting. Website located via automated research, verify before relying on it.
Design a permit-ready Cutler Bay planset with these rules baked in.
Solar Design Lab derives the SLD, electrical, and structural live as you draw, and checks your design against Florida AHJ requirements before you submit. First planset free.